SATO GY412 - Printer Language

Section 6: Basic Specifications
Page 6-2 GY412 Operator Manual
6.1 PRINTER BASIC SPECIFICATIONS (cont’d)
PROCESSING
CPU 32bit RISC-CPU 133MHz
Printer memory / Flash ROM
Main memory (Flash ROM): 16MB
RAM: 32MB
PRINTER LANGUAGE
Standard SATO Barcode Printer Language (SBPL)
INTERFACES
Interface Board
Optional communication inter-
face boards
(1) USB interface: USB B-type connector
(2) LAN interface (10/100BASE)
(3) RS-232C interface
(4) SD card slot (1 slot) * Eject type
PRINT
Method Direct Thermal only
Print Speed (selectable)
75 to 250mm/sec (Setting value: 75,100,125,150,175,200,225,250)
3 to 10 inch/sec (Setting value: 3,4,5,6,7,8,9,10)
* Print speed varies, depending on paper types to be used.
Head density (Resolution) 305 dots per inch (12dots/mm ) * Corner edge type
Printable Area Max. Length 300mm x Width 104mm (both upper and lower surfaces)
SENSING - PAPER LENGTH
Sensor
(1) I-mark sensor (Reflective type)
(2) GAP sensor (Transmissive type)