SATO GY412 - Continuous Mode Print Sequence

Section 8: Appendix
GY412 Operator Manual Page 8-19
8.10 PRINT OPERATION SEQUENCE
8.10.1 Continuous Mode (Head check disabled)
Upper head
Pitch sensor
Standby
[Notes]
The above is the base position when the I-mark sensor is selected.
Lower head
The upper head is up.
The lower head is down.
Backfeed motion starts.
Finished double sided
print of the first label.
Up
Down
ཱ཰
Up
Down
Up
Down
Up
Down
Up
Down
ཱ཰
཰
ཱ཰
ཱི཰
Up
Down
ིཱ཰
Up
Down
ཱིིཱ
Backfeed to pitch
sensor position.
The upper head is down.
The lower head is up.
Start feeding the label and
printing from the lower surface
of the first label.
The lower surface of the first
label is printed.
When the second label is fed
while printing the upper surface
of the first label, the print on the
lower surface of the second
label will start.
Finished double sided
print of the second
label.

(1) Motion

Label feed direction