SATO GY412 - Cutter Mode

Section 8: Appendix
Page 8-6 GY412 Operator Manual
8.1 CUTTER AND PRINTER MOTION (cont’d)
8.1.4.2 Tear-off Mode
The base position for printing and manual cutting in tear-off mode is shown below.
For the I-mark sensor, the top of label is the base position for tear-off.
For the GAP sensor, 1.5mm before the base position for printing is the tear-off position.
8.1.4.3 Cutter Mode
The base position for printing and cutting in cutter mode is shown below.
For the I-mark sensor, the top of label is the base position for cutting.
For the GAP sensor, 1.5mm before the base position for printing is the cutting position.
I-mark GAP
Base position for
tear-off
Base position for
printing
Base position for
printing
Base position for
tear-off
1.5mm
Label feed direction
I-mark GAP
Base position for
tear-off
Base position for
printing
Base position for
printing
Base position for
tear-off
1.5mm
Label feed direction
I-mark GAP
Base position for
cutting
Base position for
printing
Base position for
printing
Base position for
cutting
1.5mm
