SATO GY412 - Page 190

Section 8: Appendix
Page 8-8 GY412 Operator Manual
8.2 OFFSET POSITION ADJUSTMENT (cont’d)
8.2.2 Adjustment of Stop Position in Cutter and Tear-off Modes
Label stop position for the cutter and tear-off modes are adjustable within the range of +3.75mm to -3.75mm
due to the above settings on LCD screen.
Adjustment of cut position
Notes:
• The above cut position will be the stop position when the GAP sensor is selected.
• Tear-off position is adjustable in the same manner.
Adjustments
LCD setting for stop posi-
tion in cutter and
tear-off modes
Operation panel
OFFSET POSITION
+3.75mm to -3.75mm
Cut position
No adjustment
“+”adjustment
-3.75mm
+3.75mm
“-“ adjustment
Label feed direction