SATO GY412 - Page 57

Section 3: Operation and Configuration
GY412 Operator Manual Page 3-29
3.3 LCD MESSAGE DETAILS (cont’d)
3.3.1.5 Adjustment Screen
Display Normal Mode - Cancellation of print job
Onscreen
message
This message appears when the print data is
cleared completely.
Goes to the OFFLINE screen after displaying this
message about 3 seconds.
Display Adjustment screen - Adjustment of print start position on the upper surface
Onscreen
message
This adjusts the print position on the upper sur-
face.
Use the arrow buttons to change setting value
and press ENTER.
The setting value can be adjusted by ±0.25 mm
regardless of print density.
The setting range is ±3.75 mm and the default
setting is +0.00 mm.
Operation
button
Button Description
↓, ↑ Enters setting value by ±0.25 mm.
ENTER Saves the setting and goes to the OFFSET POSI-
TION screen.
CANCEL Goes to the OFFLINE screen without saving the
setting.
FUNCTION Goes to the OFFLINE screen without saving the
setting.
CANCEL PRINT JOB
YES NO
mm
+0.00
PITCH POSITION
UPPER