SATO GY412 - Page 77

Section 3: Operation and Configuration
GY412 Operator Manual Page 3-49
3.3 LCD MESSAGE DETAILS (cont’d)
Display Interface Mode - LAN communication protocol setting
Onscreen
message
Setting communication protocol.
Press ENTER.
The default setting is “STATUS4”.
Operation
button
Button Description
↓,↑, ←, → Moves the cursor.
ENTER "STATUS4" : Saves the setting and goes to the
[STATUS REPLY TIMING] screen.
"STATUS5" : Save setting value and goes to the
[ITEM NO CHECK] screen.
"STATUS3" : Saves the setting and goes to the
[ONLINE MODE] screen.
CANCEL Goes to the [INTERFACE PORT] screen without
saving the setting.
FUNCTION Goes to the [ONLINE MODE] screen without sav-
ing the setting.
STATUS3
PROTOCOL
STATUS4
STATUS5