Special Notes 1. A reverse image area is affected by the rotate commands.
Therefore, always assume the printer is in the normal print
orientation when designing and sending the Reverse Image
command.
2. If using reverse images with the form overlay, place this command
before the Form Overlay command in the data stream.
3. If the height and width to be reversed contain other than
alphanumeric data, the area is not printed.
4. If the values specified exceed the maximum ranges, the reverse
image is not created.
5. The maximum allowable settings are as follows:
SATO“Se”PrintEnginesPN9001073RevCPage5-69
Section 5. Programming Reference
M-8459Se M-8460Se M-8485Se M-8490Se
Horizontal
aaaa 001 to 896 0001 to 1216 0001 to 1024 0001 to 1344
Vertical
Default
bbbb
Expanded
bbbb
0001 to 1424
0001 to 9999
0001 to 1424
0001 to 9999
0001 to 1424
0001 to 9999
0001 to 2136
0001 to 9999
To Next Page
Loading...
