SATO M-8485Se - Status Response

STATUS RESPONSE
The second method of determining printer status is to interrograte the printer with
specific commands. The response from these commands will provide specific
information about the printer status depending upon the command. This allows the
controlling application to determine the status of a printer when it is located in a
remote location.
Printer Status (SOH + MG)
Upon Receipt of an SOH (hexadecimal 01) followed immediately by an ASCII MG
causes the printer to return a 30 byte Printer Status Word bounded by an STX-ETX
pair that reports the current operating status of the printer.
BYTE
NUMBER
HEX
VALUE
DESCRIPTION
100
01
Thermal Transfer Print Type
Direct Thermal Print Type
200
01
203 dpi Resolution
305 dpi Resoution
300
01
02
03
04
05
06
07
08
09
2 ips Print Speed
3 ips Print Speed
4 ips Print Speed
5 ips Print Speed
6 ips Print Speed
7 ips Print Speed
8 ips Print Speed
9 ips Print Speed
10 ips Print Speed
12 ips Print Speed
400
01
02
03
04
Not Supported
Not Supported
Not Supported
Label Dispense Print mode
Reserved
500
01
02
Not Supported
Not Supported
Not Supported
600
01
Dispense at head position
Dispense at dispense position
7 00 Reserved
841
42
43
Not Supported
Not Supported
Not Supported C
SATO“Se”PrintEnginesPN9001073RevCPage6-11
Section 6. Interface Specifications