SELECT LANGUAGE
ENGLISH
This selection allows the user to select the character set used
by the printer. The selections are English, French, German,
Spanish, Italian and Portuguese.
1. Press the LINE key to advance to the desired languarge
setting.
2. When the setting is correct, press the FEED key to accept
the setting and step to the next display.
IGNORE CAN/DLE
YES NO
If the printer is placed in the Multi-Item Buffer Mode (DSW2-5
= OFF), the user can chose to ignore CAN (18
H
) and DLE
(10
H
) commands used in bi-directional communications (see
Section 6: Interface Specifications). If the Single Item Buffer
Mode is chosen (DSW2-5 = ON), this display will be skipped.
PRIORITY SETTING
COMMAND LCD
This selection allows the user to assign a priority for Print
Darkenss, Print Speed and Print Offset setting methods. If
LCD is selected, the setting established via the LCD
display/menu system will be used for an incoming label job,
regardless of any different command settings. If Command is
selected, any commands in the label job will take precedence
and be used for printing the job.
1. Use the LINE key to step to the desired priority.
2. Once the desired setting is selected, press the FEED key to
accept the setting and step to the next display.
LABEL RE-DETECT
ENABLE DISABLE
This selection allows the user to disable the feeding of a blank
label upon power up. If Enable is selected, the printer will
automatically feed a label until it detects a label enge. This will
correctly position the next printed label under the print head. If
Disable is selected, the printer will not try to detect the next
label and the operator is responsible for ensuring that the label
is correctly positioned before printing.
1. Use the LINE key to step to the desired setting.
2. Once the desired setting is selected, press the FEED key to
accept the setting and step to the next display.
IEEE1284
ACK SIGNAL 00.5
If the printer is placed in the Single Item Buffer Mode (DSW2-5
= ON), this selection allows the user to set the width of the
IEEE1284 ACK pulse. In the Multi-Item Buffer Mode, this
display will be skipped.The range is 0.5 µsec to 10 µsec.
1. Use the LINE key to step the display to the desired setting.
The setting will advance in increments of 0.1 µsec each
time the LINE key is pressed until the setting reaches 10.0
µsec when it will wrap around to the 0.5 µsec setting.
2. Once the desired setting is selected, press the FEED key to
accept the setting and step to the next display.
SERVICE MODE
The Service mode is exited by powering the printer off and
then back on.
COUNTERS MODE
The Counters Mode is provided to allow the user to access the internal printer
cousters.
Page3-229001073RevCSATO“Se”PrintEngines
Section 3. Configuration
To Next Page
Loading...
