SATO M-8485Se - ADJUSTING THE LABEL SENSOR

ADJUSTING THE LABEL SENSOR
The “Se” printers can position labels using either a label gap (transmissive) or an
Eye-Mark (reflective) sensor. The sensor used is selected by DSW2-2. The gap sensor
position can be adjusted over a limited range. In addition, the signals from the
sensors can be adjusted using the LCD panel to compensate for different liner
opacities and/or Eye-Mark reflectance values.
M-8459Se M-8460Se M-8485Se M-8490Se
Max Label Width
(includes liner)
5.27" (134 mm) 6.5“ (165 mm) 5.27" (134 mm) 5.27" (134 mm)
Max Print Width 4.4" (112 mm) 6.0" (152 mm) 5.0" (128 mm) 4.4" (112 mm)
Gap Sensor
Adjustment Range
0.5" to 2.67"
14 mm to 68 mm
0.5" to 3.25"
14 mm to 82 mm
0.5" to 2.67"
14 mm to 68 mm
0.5" to 2.67"
14 mm to 68 mm)
Non-Print Area 0.12" (3 mm) 0.12" or 0.25"
3mmor6.5mm
0.12" (3 mm) 0.12" (3 mm)
SATO“Se”PrintEnginesPN9001073RevCPage2-9
Section 2. Installation
Print Head
Inside Frame
Inside Label Edge
Eye-Mark on Back Side of Liner
Minimum Width = 0.125" (3 mm)
Maximum Width
Maximum Print Width
Gap Sensor Adjustment
Non-Printable Area
Minimum Length = 0.5" (12 mm)