QR Code
Command Structure <ESC>2D3m,a,bb,c,d (,ee,f f,gg)
<ESC>DSk,nn.......n
<ESC>DNIIII,xx.......x
m = Model
0 Model 2
1 Model 1
2 Micro QR Code
a = Error Correction Level
L7%
M 15%
Q 25%
H 30%
bb = Cell Size (01 to 32 dots/cell)
d = Connection Mode
0 Normal
1 Connection (parameters ee, ff and gg will be used
if the file is split into several blocks as independent
symbols)
ee = Total Connection Number (01 - 16)
f f = Connection number of each symbol encoded as an
independent symbol (01 - 16)
gg = Connection Mode Parity Data (00
H
-FF
H
)
k = Input Data Type
1 Numeric
2 Alphanumeric
3 Kanji (shift JIS Code)
nn...n = Data
xx...x= Data Size. Used in Automatic or Manual mode with
binary data (0001 - 2953 bytes)
Special Notes 1. Contact SATO Technical Support for specific usage information.
2. Parameters “c”, “d”, “ee”, “f f” and “gg” are not used for Micro QR
Code.
3. Parameter “xx...x” is limited to 0001 to 0486 bytes for Model 1 and
Micro QR Code.
4. The data command should be used according to the input mode
or data type.
5. In Automatic Mode, the data for 80
H
to 9F
H
or E0
H
to FF
H
will be
interpreted as Kanji, not binary data
Page5-110PN9001073RevCSATO“Se”PrintEngines
Section 5. Programming Reference
To Next Page
Loading...
