TEST PRINT MODE
The Test Print Mode offers 4 different status labels for troubleshooting. If DSW3-5 is
in the OFF position, the Test Print cycle must be initiated with a Print Start signal on
the EXT connector.
V 05.00.03.00
INITIALIZING
Displays the firmware during the initialization.
TEST PRINT MODE
CONFIGURATION
This option allows you to print a test label. It is recommended
that you print a test label after you have changed any of the
settings in the Advanced Mode. The test label allows you to
verify that you indeed did make the desired changes. To enter
the Test Print Mode, power the printer on while pressing the
FEED key. The printer will beep. Release the FEED key and
the printer will display the following message on the LCD
panel:
1. Use the LINE key to step the cursor to type of test label you
wish to print. The choices are:
CONFIGURATION
BARCODE
HEADCHECK
MEMORY
FACTORY
TEST PRINT SIZE
10 CM
Note: This screen will not
be displayed for the
Memory Test Label.
Once you have selected the type of test label to be printed,
use the FEED key to accept the selection and the display
advances to the Test Print Size display. This display allows
you to select the label width.
1. Use the LINE key to select the lable width. Each time the
LINE key is pressed, the label size advances 1 cm until it
reaches a maximum width of 10 cm, at which point it will
wrap to the smallest size of 4 cm.
PRESS FEED KEY TO
STOP PRINTING
2. Pressing the LINE key accepts the selection.
3. Press the FEED key to start printing test labels
continuously.
4. Press the FEED key to stop the printer.
5. To exit the Test Print Mode, power the printer off and then
back on.
Page3-249001073RevCSATO“Se”PrintEngines
Section 3. Configuration
To Next Page
Loading...
