DEFAULT SETTING MODE
Occassionally it is desirable to reset all printer configuration settings to their original
default conditions. This allows the operator to start reconfiguration of the printer
starting from a know set of conditions.
V 05.00.03.00
INITIALIZING
Displays the firmware during the initialization.
DEFAULT SETTING
YES NO
You enter the Default Setting Mode by pressing the LINE and
FEED keys while simultaneously powering the printer on. The
printer will emit one long beep after which the FEED and LINE
keys should be released.
1. Use LINE key to select either the YES or NO.
2. Once the desired setting is selected, pressing the FEED
key will accept the selection and the printer will reset to the
original default conditions.
DEFAULT SETTING
COMPLETED
3. When the printer has completed the reset process it will
beep 3 times and the Default Setting Completed display will
appear. At this time the printer is in the default
configuration.
4. To exit the Default Setting Mode, power the printer off and
then back on.
CLEAR NON-STANDARD PROTOCOL
The standard protocol codes used by the printer can be modified to accomodate the
requirements of different host systems. However, if the printer is to be used with a
system that does not use the custom protocol codes, they can be cleared and the
default protocol codes reactivated. The default values are: STX = 7B
H
,ETX=7D
H
,
ESC=5E
H
,ENQ=40
H
,NULL=7E
H
,CAN=21
H
and OFFLINE = 5D
H
.
V 05.00.03.00
INITIALIZING
Displays the firmware during the initialization.
ALT.PROTOCOL
DEFAULT COMPLETE
To Clear Non-Standard protocol codes, DSW2-7 is placed in
the On position and the printer powered on while
simultaneously pressing the LINE and FEED keys.
1. The printer will emit one long beep at which time the LINE
and FEED keys should be released.
2. When the keys are released, the printer will replace the
Alternate protocol codes with the default values.
3. After the default setting is complete, the printer will emit two
short beeps indicating the process is complete.
4. To exit the mode, power the printer off and then back on.
SATO“Se”PrintEngines9001073RevCPage3-25
Section 3. Configuration
To Next Page
Loading...
