COMMAND DEFAULT SETTINGS
There are some types of commands that must have a value specified before a label
can be printed. If the data stream does not contain these commands, a “default” value
is assumed. The commands and the corresponding default values are:
COMMAND
DEFAULT NOTE
Print Rotation 0° (1)
Vertical Reference Point 0 (1)
Horizontal Reference Point 0 (1)
Character Pitch 2 (1)
Base Reference Point H=1, V=1 (2)
Character Expansion 1 (1)
Print Darkness 2 (1)
Print Darkness (M-8459Se) 3 (1)
Print Speed 6 ips (2)
Print Speed (M-8459Se) 4 ips (2)
NOTES:
(1) The settings for these commands will revert to the default value when the printer
receives an <ESC>Z or an <ESC>*.
(2) These values transmitted with these commands will remain in effect until a new
command is received.
Page5-8PN9001073RevCSATO“Se”PrintEngines
Section 5. Programming Reference
E
H = 200
V = 800
Label Feed
Direction
“%1”
Original
Base
Reference
Point
To Next Page
Loading...
