SATO M-8485Se - Pitch Offset

SETTING
(ASCII)
COMMAND
PARAMETER
ASCII
VALUE
DESCRIPTION
09 4 Print Darkness Level 4
09 5 Print Darkness Level 5
10 j 0 Reflective (Eye-Mark) Sensor
10 1 Transmissive (Gap) Sensor
10 2 Sensors Disabled
11 k 0 Zero Slash disabled
11 1 Zero Slash enabled
12 l 0 Reserved
13 m 0 Paper Type, Labels
13 1 Paper Type, Fan-Fold
14 n 0 Autofeed disabled
14 1 Autofeed enabled
15 o 0 Pitch Fixed
15 1 Pitch Proportional
16 p 0000 to 9999 Vertical Label Size (0 to Vmax dots)
17 q 000 to Hmax Horizontal Label Size (0 to Hmax dots)
18 r 000 to 792
-001 to -792
Vertical Offset (0 to 792 dots)
Vertical Offset (-1 to -792 dots)
19 s 000 to 792
-001 to -792
Horizontal Offset (0 to 792 dots)
Horizontal Offset (-1 to -792 dots)
20 t 00 to 99 Pitch Offset (0 to 99 dots)
21 u 00to99
-01 to -99
Tear Off Offset (0 to 99 dots)
Tear Off Offset (-1 to -99 dots)
22 v 0 Not Used
23 w 00to99
-01 to -99
DispenseOffset (0 to 99 dots)
Dispense Offset (-1 to -99 dots)
24 x 0 Reserved
25 y 0 to 64 Gap Size (0 to 64 dots)
26 z 0 Buzzer Enabled
26 1 Buzzer Disabled
Placement: Separate data stream sent to printer
Default: None
Page5-118PN9001073RevCSATO“Se”PrintEngines
Section 5. Programming Reference