HEX DUMP MODE
In addition to the Test Print Labels, the printer can print the contents of the receive
buffer in a hexadecimal format to allow the data stream to be examined for errors
and troubleshooting.
V 05.00.03.00
INITIALIZING
Displays the firmware during the initialization.
ONLINE
QTY:000000
The Hex Dump Mode is entered by placing DSW2-4 in the on
position and powering the printer on.
1. The printer is now ready to receive data.
2. Send the data stream to the printer.
3. The received data will be printed in a hexadecimal format
4. To return the printer to normal operation, place DSW2-4 in
the off position and power the printer off and then back on.
SATO“Se”PrintEngines9001073RevCPage3-27
Section 3. Configuration
To Next Page
Loading...
