SWITCHES AND SENSORS
Cover Open Switch The printer mechanism cover is fitted with a micro
switch. When the cover is opened, this switch is
activated and the printer will stop printing.
Ribbon Motion Sensor The sensor will react to the carbon ribbon unwind when
approximately 46 feet of ribbon remain. This sensor is
a motion detector that signals the printer when the
ribbon supply is turning. This sensor is used for both
the ribbon end and ribbon near end sensing.
Note: The M-8459Se Direct Thermal print engine does
not use a Ribbon Motion Sensor.
Head Open Switch When the print head is opened, this switch is activated
and the printer will stop printing.
Label Sensor This sensor unit contains two sensors for both label
gap and Eye-mark sensing.
SATO“Se”PrintEnginesPN9001073RevCPage2-5
Section 2. Installation
To Next Page
Loading...
