SATO M-8485Se - PLUG-IN INTERFACE MODULES

ERROR DESCRIPTION INDICATION REMEDY
Low Battery - Low battery condition
is detected when printer is powered
on.
ERROR LED: Blinking
Audible Beep: 1 long
Display: Card Low
Battery
Depress LINE key to print Card
Status.
Replace Memory Card battery.
Note that all data will be lost when
the battery is removed.
Card R/W Error
1. No card is inserted.
2. Card is write protected.
3. Invalid store/recall number.
4. Card has not been
initialized.
ERROR LED: On
Audible Beep: 1 long
Display: Card R/W Error
Printer must be powered off to
reset.
1. Insert card into selected slot.
2. Remove write pro.tect tab.
3. Correct program
4. Initialize card with BJF command
Warning
1. Duplicate number.
2. Data not in print area.
3. Data overflows card
memory.
Audible Beep: 1 short
Display: None
Printer will ignore invalid
commands.
1. Correct program.
2. Correct program.
3. Use card with more capacity.
EXPANDED FLASH ROM MEMORY OPTION
Adds an additional 4 MB of Flash ROM to the printer, extending the onboard Flash
ROM to 6MB total. The Expanded Flash ROM Memory Option requires the
installation of an upgraded Memory Module in the printer which replaces the
standard Memory Module.
Installation
Instructions for installing the Memory Card Option are included with the installation
kit.
TOP MOUNTED REFLECTIVE SENSOR
If there is a requirement for printing a registration mark on the top of a label instead
of on the bottom side, a Top Mounted Reflective Sensor Assembly can be installed.
This option is not available on the M-8460Se and the Left-Hand versions of the
M-8485Se, M-8459Se and M-8490Se.
PLUG-IN INTERFACE MODULES
The Series “e” printers have user changable Plug-In Interface Modules. The
Interface Module is accessible from the Rear Panel and is retained by
two screws. Use the following procedure to replace an interface molule.
1. Turn power off both the printer and the host and remove the power and interface
cables.
WARNING: Never connect or disconnect interface cables (or use a switch box) with
power applied to either the host or the printer. This may cause damage to the
interface circuitry and is not covered by warranty.
PageD-2PN9001073RevCSATO“Se”PrintEngines
Appendix D: Optional Accessories