ADVANCED MODE
The Counter Mode is accessed from the Advanced Mode.
Press the LINE key to step to the Counter Mode.
COUNTERS MODE
Pressing the FEED key will advance the display to the counter
selections.
COUNTERS
HD DSP CUT LIFE
The counters are identified in the display as:
HD:Head Counter (should be reset when print head is
replaced)
DSP: Dispense Counter (not used on “Se” printers)
CUT: Cutter Counter (not used on “Se” printers)
LIFE: Life Counter (cannot be reset)
1. Use the LINE key to step the cursor to the desired counter,
the Head (HD) counter or the LIFE counter. The default
position is the Head Counter. Use the LINE key to advance
the cursor to the desired selection.
HEAD COUNTER
0.5M
2. Once the correct setting is selected, pressing the FEED key
will display the current value (in meters) stored in the
counter. The maximum number of digits displayed is 8.
3. Pressing the FEED key again will advance the counter to
the Clear mode. All counters with the exception of the LIFE
counter may be cleared.
HEAD COUNT CLEAR
YES NO
4. Use the LINE key to select the desired setting. If you only
wanted to read the counter value, select NO. If you want to
read the counter and reset it to 0.0, place the cursor over
the YES. Once the desired setting is selected, pressing the
FEED key will advance the return you to the Counters Mode
display.
COUNTERS MODE
5. To exit the Counters Mode, turn power to the printer off and
then back on.
SATO“Se”PrintEngines9001073RevCPage3-23
Section 3. Configuration
To Next Page
Loading...
