REPRINT W/FEED
YES NO
This selection specifies whether or not the printer will print the
last printed label stored in memory when the FEED key is
pressed in the Normal Online mode.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will reprint the last label when
the FEED key is pressed when the printer is Online. If the
printer is Offline, pressing the FEED key will feed a blank
label. If No is selected, the display will advance to the next
display.
FORWARD/BACKFEED
DISTANCE DEFAULT
This dsiplay will only appear Backfeed is enabled (DSW3-4 =
OFF). The maximum backfeed distance is 255 mm.
1. Use the LINE key to select either the Default or the Manual
selection. If Default is selected, the display steps to the next
display.
FORWARD/BACKFEED
DISTANCE XXXmm
2. If Manual setting is selected, use the LINE key to advance
the distance to the desired setting. Each time the LINE key
is pressed, the Distance will advance 1 mm. The maximum
distance is 255 mm.
3. Once the desired distance is set, press the FEED key to
accept the setting and step to the next display.
EXT PIN 9 SELECT
MODE1 MODE2
This selection allows the user to select the conditions that
cause the signal on Pin 9 of the EXT connector to be true. If
Mode1 is selected, pin 9 will be true when the printer is ready
to print, i.e. it is Online and has a print job loaded (a quantity
of labels to be printed on the display). If Mode 2 is selected,
pin 9 will be true if the printer is Online.
1. Use the LINE key to step the cursor to the desired setting.
2. Once the desired setting is selected, press the FEED key to
accept the setting and step to the next display.
WEB ACCELERATION
FAST NORMAL
This selection allows the printer to use either a Normal or Fast
web acceleration. Large, heavy, label rolls should use the
Normal selection while smaller, lighter rolls can use the Fast
selection.
1. Use the LINE key to step the cursor to the desired setting.
2. Once the desired setting is selected, press the FEED key to
accept the setting and step to the next display.
EURO CODE
D5
This selection allows the user to specify the dexadecimal code
for the character which is replaced with the Euro Character.
The default is D5
H
.
1. The cursor should be positioned over the first digit
selection. Use the LINE key to step to the desired setting.
2. Press the FEED key to advance the cursor to the second
digit of the desired hexacecimal code.
3. Press the LINE key to step to the desired setting.
4. When the setting is correct, press the FEED key to accept
the setting and step to the next display.
SATO“Se”PrintEngines9001073RevCPage3-21
Section 3. Configuration
To Next Page
Loading...
