SATO M-8485Se - Page 198

BYTE
NUMBER
HEX
VALUE
DESCRIPTION
900
01
02
03
04
Print Density Level 1
Print Density Level 2
Print Density Level 3
Print Density Level 4
Print Density Level 5
10 00
01
02
Reflective (Eye-Mark) Sensor
Gap (See-Thru) Sensor
No Sensor
11 00
01
Zero Slash Disabled
Zero Slash Enabled
12 00 Reserved
13 00
01
Not Supported
Not Supported
14 00
01
Online Feed Disabled
Online Feed Enabled
15 00
01
Fixed Pitch
Proportional Pitch
16-17 00 to C80
00 to 12C0
Not Supported
18-19 00 to 340
00 to 4E0
Not Supported
20-21 00 to 3E7
FFFF to FC19
Vertical Base Reference Point Offset in dots (0 to 792)
Vertical Base Reference Point Offset in dots (-1 to -792)
22-23 00 to 320
00 to FCE0
Horizontal Base Reference Point Offset in dots (0 to 800)
Horizontal Base Reference Point Offset in dots (-1 to
-800)
24 00 to 63
FF to 9D
Not Supported
25 00 to 63
FF to 9D
Not Supported
26 00 to 63
FF to 9D
Not Supported
27 00 to 63
FF to 9D
Dispense Offset in dots (0 to 99)
Dispense Offset in dots (-1 to -99)
28 00
01
Compatibility Mode Enabled
Compatibility Mode Disabled
29 08 to 40 Not Supported
30 00
01
Buzzer Enabled
Buzzer Disabled
Page6-12PN9001073RevCSATO“Se”PrintEngines
Section 6. Interface Specifications