CONFIGURATION COMMANDS
I2abcde Serial Interface. Sets the operating parameters for the Serial RS232C
interface. Sets the default printer configuration in Flash ROM. See
Serial Interface Parameters command in the Configuration Commands
of Section 5: Programming Reference of this manual for details.
5-124
IGa Sensor Type. Selects the sensor type.
a = 0 Reflective (Eye-Mark) sensor.
1 Transmissive (See-Thru) sensor
2 Sensor not used
5-123
LD,a,b,c,d,e,
f,g,i, j j
Download Protocol Command Codes. Downloads a user defined set
of Alternate Protocol Command Codes. See Appendix E for details on
the proper usage of this command.
5-113
PCaa,bb
PCF,a,.....z
Printer Setting. Sets the default printer configuration in Flash ROM.
See Printer Setting command in the Configuration Commands of
Section 5: Programming Reference of this manual for details.
5-117
PHa Print Type. Selects the thermal printing method.
a = 0 Thermal transfer printing
1 Direct thermal printing
5-122
PMa Print Mode. Selects desired backfeed operation.
a = 0 No backfeed, continuous operation
1 Tear-Off
2 Cut, backfeed after print
3 Cut, backfeed before print
4 Cut, no backfeed
7 Dispense, backfeed after print
8 Dispense, backfeed before print
5-121
POabcc Pitch Offset. Sets the pitch type, direction and offset to be used
a = 0 Cutter
1 Dispense
2 Tear-Off
3 Continuous
b = + Positive offset
- Negative offset
cc = 00 to 99, offset value in dots.
5-113
SATO“Se”PrintEnginesPN9001073RevCPageA-12
Appendix A: Command Quick Reference
INSTRUCTION DESCRIPTION PAGE
To Next Page
Loading...
