SATO M-8485Se - Page 8

Pitch Offset ...........................5-120
Print Mode ...........................5-121
Print Type ...........................5-122
Sensor Type ..........................5-123
Serial I/F Parameters ......................5-124
SECTION 6. INTERFACE SPECIFICATIONS
Introduction ..............................6-1
Interface Types .............................6-1
The Receive Buffer ...........................6-2
IEEE1284 Parallel Interface ......................6-3
Electrical Specifications ......................6-3
Data Streams ............................6-4
Interface Pin Assignments .....................6-4
RS232C Serial Interface ........................6-5
General Specifications .......................6-5
Electrical Specifications ......................6-5
Pin Assignments ..........................6-6
Ready/Busy Flow Control .....................6-6
X-On/X-Off Flow Control ......................6-7
Universal Serial Bus (USB) Interface ..................6-7
Local Area Network (LAN) Interface ..................6-8
Bi-Directional Communications ....................6-8
ENQ/ACK/NAK...........................6-8
Enquire ...............................6-8
Status Response ..........................6-11
Accessory (EXT) Connector.......................6-18
Pin Assignments ..........................6-18
Standard Operation ........................6-19
Repeat Print ............................6-20
Error Signals ............................6-20
SECTION 7. TROUBLESHOOTING
Initial Checklist.............................7-1
Using the IEEE1284 Parallel Interface .................7-1
Using the RS232C Serial Interface ...................7-3
Using the Universal Serial Bus Interface ................7-4
Using the Local Area Network Interface ................7-4
Error Signals ..............................7-7
PN9001073RevC