SATO s84ex - Page 126

4 Operation and Configuration
124
S84-ex/S86-ex Operator Manual
Function Settings
The flowchart shows the sequence of the setting screens for the function settings. The table describes
each setting screen in detail.
button
button
button
Select SETTING
+ button
Shows when ENABLE is selected in EXTERNAL REPRINT,
YES is selected in REPRINT W/FEED,
REPRINT is selected in FUNCTION KEY,
or ENABLE is selected in CONTINUOUS PRINT.
button
button
button
button
button
button
button
button
button
button
button
button
button
button
button
Proceed to .
S-A
* Press the , , or button to select an item or set the value
accordingly. The active arrow icons are shown on the screen.
* Pressing the button on each screen will revert to the SERVICE
MODE setting screen.
35(1'7<3(
1250$/
027,21
button
button
Shows only if you have installed the optional RFID kit and
enabled RFID mode.