2 Installing the Printer
27
S84-ex/S86-ex Operator Manual
2.3
Installing the Printer onto a Support
Structure/Applicator
This printer must be installed onto a support structure/applicator for correct operation.
The printer has five bores on the center frame for installing to a support structure.
Attach five bolts to the five bores on the center frame to install the printer onto the support structure.
WARNING
Make sure that you use the designated bolts that can accommodate the weight of the printer.
If you do not install the printer correctly, it could fall out of the support structure. This may cause injury.
The picture below shows the installation of the printer onto the support structure.
Note
This picture is for an instructional display purpose only and is not to be interpreted as a precise example.
To Next Page
Loading...
