SATO s84ex - Test Print Mode; Default Setting Mode

8 Appendix
299
S84-ex/S86-ex Operator Manual
8.1.8 Test Print Mode
8.1.9 Default Setting Mode
MCS DISABLE No Yes
Pre-Encoded Tag DISABLE No Yes
Chip Manufacture IMPINJ No Yes
MCS Prefix AUTO No Yes
MCS Prefix Digit 0 DIGIT(S) No Yes
MCS Prefix Data 0 No Yes
Setting Item Initial Value
Default
(User)
Default
(Shipping)
TEST PRINT MODE CONFIGURATION - -
TEST PRINT SIZE S84-ex: 10 cm
S86-ex: 16 cm
(When CONFIGURATION, BARCODE,
HEAD CHECK is selected)
--
LARGE
(When FACTORY, WLAN is selected)
--
LABEL LENGTH 10cm
(When CONFIGURE LIST is selected)
--
PITCH POSITION Varied No No
OFFSET POSITION Varied No No
DARKNESS 50 Yes No
Setting Item Initial Value
Default
(User)
Default
(Shipping)
DEFAULT MODE PRINTER SETTING - -
DEFAULT PRINTER SETTING NO - -
DEFAULT ALT.PROTOCOL NO - -
DEFAULT WLAN SETTING NO - -
Setting Item Initial Value
Default
(User)
Default
(Shipping)