8 Appendix
314
S84-ex/S86-ex Operator Manual
8.5
Input/Output Signal of the External Signal
This section provides additional information about setting the pin number of the input/output signal in the
INPUT SIGNAL/OUTPUT SIGNAL screen of the advanced mode menu.
Setting Conditions
*
1
You cannot select “-” for the PRINT END output signal.
Note
• When multiple errors are allocated to one pin, the signal is output when one of the errors occurs.
• All errors need to be released in order to switch the signal output back to normal.
Signal Name Input/Output
Pin No.
(Default Value)
Overlapping Available Pin No.
PRINT START Input 20 Not Allowed
20, 8
Reprint Input 8 Not Allowed
FEED Input 21 Not Allowed 21, 7, -
Note: When “-” is selected, the
function is disabled.
LABEL NEAR Input 7 Not Allowed
Paper End Output 17 Allowed
4, 5, 6, 16, 17, 18, -
Note: When “-” is selected, there is
no output.
Ribbon End Output 16 Allowed
MACHINE ERR Output 4 Allowed
PRINT END *
1
Output 5 Not Allowed
ONLINE Output 6 Allowed
RIBBON NEAR Output 18 Allowed
To Next Page
Loading...
