SATO s84ex - Page 156

4 Operation and Configuration
154
S84-ex/S86-ex Operator Manual
AUTO ONLINE
Set the auto online function.
This function sets the printer status at power on.
• YES: Start up the printer in online mode.
• NO: Start up the printer in offline mode.
PRINT OFFSET
When setting the print position in the vertical direction “V”:
Set the offset value with ‘+’ from the print reference position to move the
print position opposite the feed direction and value with '-' to move the print
position in the feed direction.
When setting the print position in the horizontal direction “H”:
Set the offset value with '+' from the print reference position to move to the
left side and value with '-' to move to the right side of the printer (when
facing the front of the printer).
The setting range varies depending on the model as follows:
HEAD DOT DENSITY
Toggle the head dot density from 12 dots/mm to 6 dots/mm and vice versa.
The following options are available:
• 100: Approximately four inches. Effective for S84-ex only.
• 150: Approximately six inches. Effective for S84-ex and S86-ex.
• 300: Approximately twelve inches. Effective for S84-ex and S86-ex.
Note
Shows only if the head dot density is 12 dots/mm and COMPATIBLE
MODE is enabled. For details on the compatible mode, refer to Section
8.3 About Compatible Mode.
Model V (dot) H (dot)
S84-ex (203 dpi) ±0-9999 ±0-832
S84-ex (305 dpi) ±0-9999 ±0-1248
S84-ex (609 dpi) ±0-9999 ±0-2496
S86-ex (203 dpi) ±0-9999 ±0-1340
S86-ex (305 dpi) ±0-9999 ±0-2010