SATO s84ex - Page 70

4 Operation and Configuration
68
S84-ex/S86-ex Operator Manual
SELECT FILE
Select the file name of the print data using the / buttons and then
press the ENTER button.
The “XXXXXX” in the screen shows the file name of the print data.
Only existing file names in the selected interface are displayed.
When sequential data are included in the file, the printer goes to the SET
START NUMBER screen.
When sequential data are not included in the file, the printer goes to the
OUTPUT LABEL screen.
SET START NUMBER
This is the edit screen of the sequential data included in the read data.
Move the cursor using the
/ buttons, change the value using the
/ buttons and then press the ENTER button.
The “X/X” in the screen shows the currently edited sequential data number
and total sequential data number.
DIGIT is the digit number of the selected cursor.
The screen may be decimal or hexadecimal according to the read data.
The maximum number of DIGIT is 99.
Note
Shows only when there is sequential data.
OUTPUT LABEL
This screen allows you to specify the print number.
Move the cursor using the
/ buttons, change the value using the
/
buttons and then press the ENTER button.