SATO s84ex - Page 85

4 Operation and Configuration
83
S84-ex/S86-ex Operator Manual
IGNORE CAN/DLE
Ignore or acknowledge the CAN/DLE code of the received data.
• YES: Ignore the CAN/DLE code.
• NO: Do not ignore the CAN/DLE code.
Note
Shows only if PROTOCOL is set to STATUS4.
SNTP FUNCTION
Enable or disable the SNTP function.
• ENABLE: Perform the time correction of the calendar IC.
• DISABLE: Do not perform the time correction of the calendar IC.
Note
Shows only if the calendar IC is installed and the LAN interface is selected.
IPv4/6 select
Select IP address type of SNTP.
•IPv4
•IPv6
Note
Shows only if the SNTP function is enabled.
NTP IPv4 ADDRESS
Set the IPv4 address for NTP server.
The setting range is from 0.0.0.0 to 255.255.255.255.
Note
Shows only if the SNTP function is enabled.