SATO s84ex - Page 87

4 Operation and Configuration
85
S84-ex/S86-ex Operator Manual
SNMP SET SELECT
Select SNMP settings.
• SNMP SETTING: Sets the SNMP settings. When select it, goes to
“SNMP setting” screen.
• SNMP TRAP SET: Selects the trap number of SNMP. When select it,
goes to “SNMP trap setting” screen.
SNMP SETTING
Select community and authentication of SNMP.
• SNMPv1/v2c [1]: Goes to “Community name” screen.
• SNMPv1/v2c [2]: Goes to “Community 2 name” screen.
• SNMPv3 [1]: Goes to “Authentication 1 user name” screen.
• SNMPv3 [2]: Goes to “Authentication 2 user name” screen.
SNMP TRAP SET
Select the trap number of SNMP from 1 to 3.
• TRAP [1]
• TRAP [2]
• TRAP [3]
TRAP TYPE SELECT
Select SNMP trap type.
•SNMPv1
•SNMPv2c
•SNMPv3
Note
The setting will be effective only if you power on the printer again.