SATO s84ex - Page 91

4 Operation and Configuration
89
S84-ex/S86-ex Operator Manual
COMMUNITY NAME
Input SNMP trap community name.
Press the
/ buttons to shift the cursor and press the / buttons to
change the value.
Press the ENTER button to save the value and proceed to the next
setting screen.
Note
• When the authentication name is less than 8 characters, there will be
buzzer sounds and it will not move to the next screen.
• Up to 32 alphanumeric characters and symbols (from 20H to 7EH) can
be set.
• Specify “ ” to input a space.
• The setting will be effective only if you power on the printer again.
USER NAME
Input SNMP trap authentication user name.
Press the
/ buttons to shift the cursor and press the / buttons to
change the value.
Press the ENTER button to save the value and proceed to the next
setting screen.
Note
• Up to 32 alphanumeric characters and symbols (from 20H to 7EH) can
be set.
• Specify “ ” to input a space.
• The setting will be effective only if you power on the printer again.
AUTH PROTOCOL
Select SNMP trap authentication protocol.
The options are as follows:
• NONE
• MD5
• SHA-1
Note
The setting will be effective only if you power on the printer again.