SATO s84ex - Page 93

4 Operation and Configuration
91
S84-ex/S86-ex Operator Manual
TRAP IPv4 ADR
Set the IPv4 address where trap is output.
The setting range is from 0.0.0.0 to 255.255.255.255.
Note
Shows only if the SNTP function is enabled.
TRAP IPv6 ADR
Set the IPv6 address where trap is output.
The setting range is from 0000:0000:0000:0000:0000:0000:0000:0000 to
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF.
Note
Shows only if the SNTP function is enabled.
FINISH SETTING?
Confirm to complete the setting.
• YES: Returns to the user mode screen.
• NO: Returns to the NOTICE FUNCTION screen to select an item.