OPM 100 en-GB 4
© Scania CV AB 2023, Sweden
Scania Power Solutions engine warranty for industrial engines
Scania Power Solutions en-
gine warranty for industrial
engines
Emission control systems
warranty for USA
Only applicable to engines used in the U.S.A.
Emission control system warranty
statement
General warranty provisions
The emission control systems of your new Scan-
ia Engines (“Scania”) industrial diesel engine
were designed, built and tested using genuine
parts, and were certified as being in conformity
with federal emission control regulations. Scania
warrants to the original owner, and to each sub-
sequent owner, of a new Scania industrial diesel
engine (“You”) that the engine:
1. Was designed, built and equipped so as to
conform at the time of sale with all applica-
ble regulations under Section 213 of the
Clean Air Act, 42 U.S.C. § 7547, for their
full useful life and designed, built and
equipped so as to conform with all applicable
regulations adopted by the California Air Re-
sources Board pursuant to its authority under
Chapters 1 and 2, Part 5, Division 26 of the
California Health and Safety Code, and;
2. Is free from defects in material and work-
manship which would cause such engine to
fail to conform to applicable regulations for
its warranty period or otherwise cause the
failure of a warranted part to be identical in
all material respects to the part as described
Table of Contents
General warranty provisions 4
Warranty period 4
Parts covered by the Warranty 5
General warranty limitations 6
Specific warranty exclusions 7
Customer support 7
in the engine manufacturer's application for
certification.
Where a warrantable condition exists, Scania
will repair your heavy-duty off-road engine at no
cost to You including diagnosis, parts, and labor.
Warranty period
This warranty shall apply for one of the follow-
ing periods, whichever occurs first:
• 3,000 hours of operation as determined by a
device to measure hours of use, or
• Five years
Each engine is equipped with a device to meas-
ure hours of use. If that device fails to account for
hours of use due to defects in materials or work-
manship, the engine shall be warranted for a pe-
riod of five years. The warranty period shall
begin on the date the engine is delivered to the
first ultimate purchaser who, in good faith, pur-
chases the engine for purposes other than immi-
nent resale.
The Warranty on emission-related parts
shall be interpreted as follows:
1. Any warranted part which is not scheduled
for replacement as required maintenance in
Scania's written instructions for maintenance
and use of the engine by owner shall be war-
ranted for the warranty period defined above.
If any such part fails during the period of
warranty coverage, it shall be repaired or re-
placed by the engine manufacturer according
to Subsection (4) below. Any such part re-
paired or replaced under the Warranty shall
be warranted for the remaining warranty pe-
riod.
2. Any warranted part which is scheduled only
for regular inspection in Scania's written in-
structions for maintenance and use of the en-
gine by owner shall be warranted for the
warranty period defined above. A statement
in such written instructions to the effect of
“repair or replace as necessary” shall not re-
duce the period of warranty coverage. Any
such part repaired or replaced under warran-
ty shall be warranted for the remaining war-
ranty period.
To Next Page
Loading...
Need help?
General
