Maintenance
OPM 100 en-GB 46
© Scania CV AB 2023, Sweden
Maintenance interval
Daily First time at Interval (hours) Minimum
first start 500 500 1,000 2,000 6,000 annu-
ally
every
5
years
R
SMLXL
Lubrication system
Checking the oil level XX
Changing the oil
1
1. For engines that comply with EU Stage 5/China IV, see the table Oil change interval EU Stage 5/China IV.
X
XXXXX
Renewing/cleaning rotor in cen-
trifugal oil cleaner
X
2
2. XPI engines where EU Stage 3/US Tier 3 or lower emission legislation applies.
X
3
3. XPI engines where EU Stage 4/US Tier 4 or higher emission legislation applies.
XX
Renewing the oil filter XXXXXX
Air cleaner
Reading the vacuum indicator X XXXXX
Renewing the filter element XX X
Renewing the safety cartridge XX X
Cooling system
Checking the coolant level X X XXXXX
Checking the coolant's anti-
freeze and corrosion protection
XXXX
Changing the coolant and clean-
ing the cooling system
XX
Fuel system
Checking the fuel level XX
Renewing the fuel filter XXX X
Fuel tank venting filter X
(X)
4
4. Applies every other year.
Other
Checking the drive belt XXXXX
Checking for leakage XXXXX
Checking and adjusting the
valve clearance
XXX
Renewing the reductant filter XXX
Cleaning the reductant tank filler
filter
XXXX
Checking and cleaning the re-
ductant tank vent
XXXXX
Checking/renewing the particu-
late filter
4,500 hours
5
5. The change interval very much depends on the average load and application type. See the section Maintenance interval particulate
filter.
To Next Page
Loading...
