Fuel system
OPM 100 en-GB 88
© Scania CV AB 2023, Sweden
Bleeding the fuel system
Venting the fuel system using a suc-
tion tool
Tool
Scania recommends venting the fuel system us-
ing suction tools rather than with a hand pump.
This is a quicker and simpler method, which en-
sures a complete venting.
Use a suitable container. The fuel collected must
be disposed of as specified in national and inter-
national laws and regulations.
1. Open the bleed nipple on the high pressure
pump and connect the suction tool.
2. Hold the suction tool straight and draw out at
least a full container of fuel.
3. Once the fuel coming out of the hose is free
of air bubbles, then venting is complete.
4. Close the bleed nipple on the high pressure
pump. Remove the hose and suction tool.
5. Start the engine and check that there are no
leaks.
Designation Illustration
Suction tool
To Next Page
Loading...
