Other
OPM 100 en-GB 94
© Scania CV AB 2023, Sweden
Checking for leakage
If serious leakage occurs, contact your nearest
workshop.
1. Start the motor.
2. Check for oil, coolant, fuel, air or exhaust
leakage.
3. Tighten or renew leaking connections.
Check the overflow holes which show
whether the O-rings between the cylinder
liners and crankcase are leaking.
4. Check whether the drain hole on the coolant
pump is blocked. If there is leakage, renew
the seal in the pump or the complete coolant
pump assembly.
To Next Page
Loading...
