Fuel system
OPM 100 en-GB 91
© Scania CV AB 2023, Sweden
Renewing the fuel tank venting filter
1. Remove the hose from the filter and then re-
move the filter.
2. Clean around the tank pick-up unit and along
the rubber hose.
3. Carefully clean the area on the surface of the
tank where the filter is to be fitted. Clean off
heavy dirt with water and detergent. Remove
grease and oil residue with a degreasing
agent. Remove adhesive residue with solvent
naphtha or similar.
4. Adjust the tank ventilation connection to the
correct position.
5. Wait so that the detergent has time to evapo-
rate before the filter is fitted.
6. Fit the filter to the hose.
7. Remove the protective tape from the fuel fil-
ter. Push the filter vertically into position by
hand and maintain the pressure for at least 5
seconds.
8. Refit the hose.
The tank ventilation filter must be positioned
vertically in order to function correctly. Ensure
that there are no kinks in the hose or any chafing
or over-extension. The ideal fitting temperature
of the component parts is 21°C-38°C.
Protective tape on venting filter.
To Next Page
Loading...
