OPM 250 en-GB 24
©
Scania CV AB 2016, Sweden
Starting and running
Engine shutdown
1. Run the engine without a load for a few min-
utes if it has been run continuously with a
heavy load.
2. Switch off the engine.
The battery voltage must remain on for a few
seconds after the 15 voltage is switched off so
that the control units can store the values and
switch to standby mode.
10 prohibited engine shutdowns will cause a
torque reduction (70% of fuel quantity). Reset
the engine by switching it off correctly once.
There is risk of post boiling and of damage to the
turbocharger if the engine is switched off with-
out cooling.
The power must not be switched off before the
engine has stopped.
To Next Page
Loading...
