How to fix burns on the cutting surface of Scheppach Saw?
Burns on the cutting surface of your Scheppach Saw can occur for several reasons. Ensure you insert a sharpened saw blade. For longitudinal cuts, use a saw blade with 20 or 28 teeth. Check that the longitudinal stop is parallel, and if not, exchange it. Finally, ensure the slide carriage is aligned with the saw blade.
Why does the saw blade get loose on my Scheppach Saw after turning off the motor?
If the saw blade gets loose after turning off the motor, it's likely because the fastening nut wasn't tightened sufficiently. Make sure to tighten the fastening nut, which has an M20 left-handed thread.
Why Scheppach HS100S Saw motor does not start?
If your Scheppach Saw motor isn't starting, here are a few things to check: * First, check the mains fuse to ensure it hasn't blown. * Next, inspect the extension cable for any defects and replace it if necessary. * If these steps don't resolve the issue, have an electrician check the motor and switch connections, as well as the motor and switch themselves, for any defects.
What to do if Scheppach HS100S Saw motor is not supplying power and fuse tripping?
If your Scheppach Saw motor isn't supplying power and the fuse keeps tripping, it could be due to a couple of reasons. One possibility is that the cross-section of the extension cable is insufficient; refer to the “Electrical Connection” section in the operating manual. Another reason could be an overload caused by a blunt saw blade, so try replacing the saw blade.
Details the components and parts of the HS100S circular table saw.
Instructions on how to safely unpack the machine and check contents.
Provides essential safety guidelines for operating power tools, covering work area, electrical, and personal safety.
Ensures a clean, well-lit, and safe operating environment, keeping bystanders away.
Focuses on the correct use and maintenance of safety guards on table saws.
Explains the causes of kickback and provides critical safety measures to prevent it.
Step-by-step guide for attaching the bench extension to the saw.
Instructions for assembling the machine's frame and support legs.
Details on how to properly set and mount the riving knife.
Guide for installing and removing the saw blade guard.
Procedures for safely changing the saw blade.
Explains how to operate the power switch and adjust the cutting depth.
Instructions for setting the saw blade angle for bevel cuts.
Guide on using the rip fence for longitudinal cuts and setting cutting width.
Details on performing longitudinal cuts, including narrow workpieces.
Instructions for making angled and cross cuts using the appropriate accessories.
Routine cleaning and upkeep procedures for the machine.
General| Blade bore | 30 mm |
|---|---|
| Blade diameter | 250 mm |
| Number of teeth | 24 |
| Idle speed (max) | 5000 RPM |
| Cutting depth (90º) | -, 85 mm |
| Maximum cutting height | 85 mm |
| Saw blade included | - |
| Height adjustment range | 0 - 85 mm |
| Input power | 2000 W |
| AC input voltage | 220-240 V |
| AC input frequency | 50 Hz |
Weight and Dimensions| Depth | 940 mm |
|---|---|
| Width | 780 mm |
| Height | 1100 mm |
| Weight | 19400 g |
| Bench depth | 485 mm |
| Bench width | 642 mm |
To Next Page
