Maintenance
4. Mark the installation position of the base jaws (3) on the
housing (11).
5. Unscrew the screws and remove the cover (6).
6. IMPORTANT!The cylinder piston is under spring tension.
Remove carefully.
Unscrew screw (8) carefully and take cylinder piston (5), spring
(10) and the spacer (4) out of the housing (11).
7. Push the wedge hook (1) out of the housing (11).
8. Take base jaws (3) out of the housing (11).
9. Remove old seals (2, 7 and 9).
10. Clean guiding areas.
11. Attach new seals (2 and 9) from the seal kit.
12. Re-lubricating guiding areas
13. Insert base jaws (3) into the housing (11). IMPORTANT!Observe
installation position of the base jaws (3) in the housing (11).
14. Insert wedge hook (1) into the housing (11).
15. Insert spring (10) and spacer (4) into the housing (11).
16. Place the cylinder piston (5) in the housing (11) and while
doing so, observe the installation position of the
magnets, }7.6 [
/
55].
17. Align the cylinder piston (5) exactly.
18. Tighten the screw (8) and secure with medium-strength
threadlocker.
Tightening torque: }7.7 [
/
56]
19. Place cylinder piston (5) on the assembly device (13), slide
towards the housing and tighten screw (8). Secure the screw
with medium-strength threadlocker.
Tightening torque: }7.7 [
/
56]
20. Insert flat gasket (7).
21. Fasten the cover (6) with the screws.
Tightening torque: }7.7 [
/
56]
22. Fasten the cover (12) with the screws.
23. Mount product onto the system/machine.
24. Connect all compressed air lines.
5302.00 | JGP-P | Assembly and Operating Manual | en | 1469637
To Next Page
Loading...
