Maintenance
14.00 | SRU | Assembly and Operating Manual | en | 389439 35
8 Maintenance
8.1 Notes
DANGER
Danger of explosion in potentially explosive areas!
l
Observe supplementary sheet for products with explosion-
resistant versions "SRU -...-EX".
Original spare parts
Use only original spare parts of SCHUNK when replacing spare and
wear parts.
8.2 Maintenance interval
CAUTION
Material damage due to hardening lubricants!
Lubricants harden more quickly at temperatures above 60°C,
leading to possible product damage.
l
Reduce the lubricant intervals accordingly.
Interval (million
cycles)
for SRU 8 - 14
Maintenance work
2 Clean all parts thoroughly, check for damage
and wear, if necessary replace seals and
wearing parts, }8.4 [/37].
l
Position of the wearing
parts, }8.4.4 [/38]
l
Seal kit, }1.4.1 [/7]
2 Treat all grease areas with lubricant.
Oil or grease external steel parts. }8.3 [/36].
2 For H variant:
Check that the shock absorber is working, if
necessary replace the shock
absorber, }8.4 [/37].
2 For S variant:
Check that the elastomer is working, if
necessary replace the elastomer, }8.4 [/37].
To Next Page
Loading...
