To Next Page

To Previous Page

INCU-SHAKE Compact Stackable shaking Incubator Manual V2023.1

6.3.1 CTRL MODE-- Switch of Control Mode - Temperature & Speed

The incubator can be set to run with fixed functional parameters settings, or with

program up to 10 different segments, each with their own Ramp Time, Ramp End

Temperature, Hold Time and Speed.

To select between Fixed Value mode and Programmable mode, follow the below

steps,

⚫ Press "Stop" button in the home page to stop the current operation.

⚫ Enter "FUNC" page.

⚫ Press the "CTRL MODE" to switch the mode between "FIXED" and "PROG".

6.3.2 KEEP-- Switch of Keep Function-Temperature Holding Function

This function will enable or disable the system to keep constant temperature

controlling at the temperature setpoint while the system is not in operation, or once

the timer runs out.

With this function enabled, the unit can be used for static incubation while it’s in

standby mode.

Under Programmable mode, the temperature will remain under control at the ramp

end temperature setpoint of last segment even when the program operation is

finished.

If it is disabled, temperature would be no longer under control as shaking motion

stops.

To switch this function, follow the below steps,

⚫ Press "Stop" button in the home page to stop the current operation.

⚫ Enter "FUNC" page.

⚫ Press the "KEEP" to enable/disable the temperature holding function

6.3.3 LIGHT MODE-- Switch of Control Mode - Photosynthetic Lighting (Option)

When equipped with LED Photosynthetic Lighting, the lighting function can be set to

run under fixed value mode with fixed functional parameters settings, or under

programmable mode, with program up to 10 different segments, each with their own

Ramp Time, Ramp End Light Outputs, Hold Time, to simulate natural environment.

This function will enable or disable the photosynthetic lighting control system.

To switch this function, follow the below steps,

⚫ Press "Stop" button in the home page to stop the current operation.

⚫ Enter "FUNC" page.

⚫ Press the "LIGHT MODE" to switch the photosynthetic lighting control between

“FIXED” and “PROG” mode

Special Remind!

Make sure the unit is stopped (by pressing “STOP”) before changing the

state of “CTRL MODE".

SciQuip Incu-Shake Compact User Manual

Questions and Answers: