INCU-SHAKE Compact Stackable shaking Incubator Manual V2023.1
31
Blue—Ramp End Blue Light Output button
This function indicates the ideal red light output for the system to reach for the
segment. Use the keyboard to enter the ramp end red light output from 0-100%.
HOLD—Hold Time
This function indicates the time of hold step, which is the length of time that the unit
has to maintain the (Ramp End) light outputs for the segment. Use the keyboard to
enter the hold time from 0-9999mins.
LAST—“Last” Button
Press it to return to the set page of previous segment.
NEXT—“Next” Button
Press it to forward to the set page of next segment.
⚫ Start the program operation.
Switch the "LIGHT MODE" in the "SET" page to "PROG " mode. The program
will start according to the saved program.
⚫ Pause the program operation
To pause the program that is in operation, press the "LIGHT" switch in the
home page to "OFF". The timer will be paused. Switch the "LIGHT" to "ON" to
resume the current program.
⚫ Exit the program operation
Different from the temperature and speed system, there is no need to set a
termination point for the program. So the program will keep running in cycles
continuously until it's switched off manually.
To manually exit the program that is in operation, switch the "LIGHT MODE" in
the "SET" page to "FIXED " mode. The program will exit the current program
operation, and switch back to Fixed Value control mode.
6.6 Setting Defrosting Cycle
This unit is equipped with automatic defrosting function. When the incubator is set to
run at lower temperature set point, proper settings of defrosting cycle will optimize the
performance in long term operation.
When the defrosting cycle is running, the circulating fan stops running, and control
system activate the defrosting cycle.
To Next Page
Loading...
Need help?
General