TROUBLESHOOTING GUIDELINES
ENGINE LACKS ACCELERATION OR POWER (cont’d)
3. Engine management system fault detected (check engine pilot lamp is
ON).
– Refer to MONITORING SYSTEM in SPECIAL PROCEDURES.
4. Clogged injectors.
– Refer to an authorized Sea-Doo dealer.
5. Low fuel pressure.
– Refer to an authorized Sea-Doo dealer.
6. Water in fuel.
– Siphon and replace.
7. Engine damaged by water ingestion.
– Refer to an authorized Sea-Doo dealer.
WATERCRAFT CAN NOT REACH TOP SPEED
1. Jet pump water intake clogged.
– Clean. Refer to SPECIAL PROCEDURES section.
2. Damaged impeller or worn-out wear ring.
– Replace. Refer to an authorized Sea-Doo dealer.
3. Engine management system fault detected (check engine pilot lamp is
ON).
– Refer to MONITORING SYSTEM in SPECIAL PROCEDURES.
4. Faulty supercharger and/or intercooler (supercharged models).
– Refer to an authorized Sea-Doo dealer.
ABNORMAL NOISE FROM PROPULSION SYSTEM
1. Weeds or debris jammed around impeller.
– Clean and check for damage.
2. Damaged impeller shaft or drive shaft.
– Refer to an authorized Sea-Doo dealer
.
3. Water intrusion in jet pump causing bearing seizure.
– Refer to an authorized Sea-Doo dealer.
WATER FOUND IN BILGE
1. Bailer system malfunction.
– Have system inspected by an authorized Sea-Doo dealer.
94
______________