40
6) Navigation Light Switch
A 3-POSITION NAV/OFF/ANC PUSH TYPE
SWITCH
Press switch to first position to turn on
the stern light (anchorage position).
Press switch to second position to turn
on the bow and stern lights.
Press to OFF position to turn off navi-
gation lights.
NOTE: Switches and gauges are lit
when navigation lights are turned on.
Lights may be operated without the
safety lanyard on its switch.
7) Bilge Pump Switch
A 2-POSITION PUSH TYPE SWITCH
Press switch to ON position when man-
ual operation of the bilge pump is re-
quired (after cleaning, storage, etc.).
Turn switch to OFF when finished.
CAUTION: Using the bilge pump for
a prolonged time when the engine is
not running will discharge the bat-
tery and pump will be damaged.
NOTE: The bilge pump may be operat-
ed without the safety lanyard on its
switch.
CAUTION: Ensure to always turn
pump OFF when bilge is empty or
before operating the engine above
idle. Bilge pump will then switch to
automatic mode.
Automatic Bilge Pump
The automatic bilge pump evacuates
water from the bilge. A water sensor
detects the water, activating the bilge
pump. After the water is pumped out,
the pump shuts-off automatically. This
automatic mode is working at all times:
with/without safety lanyard on its
switch and with/without engine run-
ning.
CAUTION: When the main battery
cut-off switch is turned OFF while
boat is moored, the automatic bilge
pump will start if water comes up in
the bilge.
WARNING
Navigation lights should always
be used between sunset and sun-
rise. Ensure the stern light is in-
stalled. See REMOVABLE STERN
LIGHT in this section for location
and installation.
F00H1DY F00H1HY
lmo2005-006a_1.book Page 40 Wednesday, July 7, 2004 1:06 PM
To Next Page
Loading...
Need help?
General
