Sea-doo Utopia - Pre-Operation Checks

59
PRE-OPERATION CHECKS
Some of the following items may not have been previously covered in this guide,
however they will be described in the MAINTENANCE or SPECIAL PROCE-
DURES section. Please refer to these portions to have more detailed information.
Before operating the boat, verify the following:
SUMMARY

WARNING
The pre-operation check is very important before operating the boat. Al-
ways check the proper operation of critical controls, safety features and
mechanical components before starting. If not done as specified here, se-
vere injury or death might occur. Bring all safety equipment required by
local laws.

WARNING
Engine should be off and the safety lanyard must always be removed from
its switch before verifying any of the following. Only start boat once all
items have been checked and operate properly.
ITEM OPERATION ✓
Safety lanyard ignition switch Check operation.
Hull Inspect for damage.
Jet pump water intake Inspect/clean.
Bilge Drain. Ensure plugs are secured.
Battery Inspect tightness of cables and retaining straps.
Main battery cut-off switch Ensure it is in the ON position.
Navigation lights Check operation.
Fuel tank and oil reservoirs Refill.
Engine compartment Verify fuel/oil system components.
Steering Check operation.
Throttle/shift lever system Check operation.
Bilge blower and bilge pump Check operation.
Mandatory safety boating
equipment
Check operation.
Storage compartment covers and
engine cover
Ensure they are closed and latched.
lmo2005-006a_1.book Page 59 Wednesday, July 7, 2004 1:06 PM