82
General Inspection and
Cleaning
Inspection
Check engine compartment for any
damage. Ensure all hose clamps are
properly secured and no hose is
cracked, kinked or showing any other
damage.
Inspect muffler, battery, fuel tank and
oil reservoir fastening devices. Visually
check electrical connections for corro-
sion and tightness.
Inspect hull and jet pump water intake
grate for damage. Replace or have
damaged parts repaired.
Cleaning
The bilge should be cleaned by the deal-
er to remove any possible fuel/oil/
electrolyte deposits and mildew.
Occasionally, wash the body with hot
water and soap (only use mild deter-
gent). Remove any marine organisms
from engine and/or hull. Apply non-
abrasive wax.
CAUTION: Never clean fiberglass
and plastic parts with strong deter-
gent, degreasing agent, paint thin-
ner, acetone, etc.
Wash windscreen with Bombardier
cleaner or equivalent (P/N 293 110 001
— 400 g (14 oz)) and water. For fine
scratches and scuff marks removal,
use a windshield polisher for acrylic, lu-
cite, polycarbonate and similar materi-
als.
Stains may be removed from seats
and fiberglass with Knight’s Spray-
Nine* from Korkay System Ltd or the
equivalent.
Respect the environment by ensuring
fuel, oil or cleaning solutions do not
drain into the waterways.
WARNING
If any gasoline leak and/or odors
are present, do not start the en-
gine. Have the boat serviced by an
authorized SEA-DOO sport boat
dealer.
lmo2005-006a_1.book Page 82 Wednesday, July 7, 2004 1:06 PM
To Next Page
Loading...
