7 Appendix 1: Fitting an external antenna
Follow these instructions if the installation requires an external antenna.
1 Loosen the sealing screws and carefully remove the communication module.
2 Loosen the sealing screws and remove the terminal cover.
3 Feed the cable through the cable hole between the module area and the terminal block cover area.
4 The external antenna connectors are located on the back of the module.
5 Be careful when screwing the SMA connector. Do not use excessive force.
6 Fit the cable into the cable clips on the module.
7 The cable passes through the antenna slot on the edge of the communication module.
Communication
Terminal
Cover
SMA antenna
Slot for external
BGX701-160-R01
Sprint 211 Installation Manual Page 41 of 48
To Next Page
Loading...
