• ╚═▷ SOTF . Enabling•
Enabling Description
Breaker Pos. A (manual) CLOSE command is determined based on the breaker position. (Note that
the determination of breaker positions needs to be congured separately.)
Close Command A CLOSE command being executed enables the »SOTF« module.
Selection list referenced by the following parameters:
• ╚═▷ SOTF . Trigger•
• ╚═▷ ExP[2] . Condition•
Description
“-”
I> . Pickup Signal: Pickup
I>> . Pickup Signal: Pickup
I>>> . Pickup Signal: Pickup
Ipeak> . Pickup Signal: Pickup
Prot . Pickup Signal: General Pickup
101WIC1WIC1-1.0-EN-REF
11 Selection Lists
To Next Page
Loading...
Need help?
General